Step 4: Replacing the driver's mirror
If the outer plastic mirror cap does not have the same color as your mirror, you can easily replace the lids. Caps have a code of 3C8 857 537 C9X, with the last three digits indicating color - in this case black-pearl.
Place a straight plastic tool on the right of the mirror, just above the flash. Slide the lever towards you, turn the tool to the left, and then pull the lid out.
To remove the mirrors, the tweeter must come out. Here enough attention is needed because the plastic plugs of the tweeter are easily broken and the tweeter as a spare costs 60 euros.
The tweeter snaps into the inner mirror socket with 3 elastics, two of which are removed.
Use a plastic tool as a lever to slowly unclip the plastic sockets. Start over and with the tool that has the notch in the middle, push the top of the plastic piece out.
For the bottom, use a screwdriver or plastic tool as a lever.
Once the tweeter comes out, remove the 2 rubber straps from its plastic sockets, because to lock it later you must first place it in the mirror sockets and then snap the tweeter over it.
Now you see 2 screws holding the mirror. Thoroughly unscrew the plastic liner until the third screw pops up and unscrew using a magnetic screwdriver. Be careful not to drop a screw into the door.
Unclip the mirror connector from the door guide. To do this, pull out the red small piece of plastic, push the black clip and pull it out. Remove the mirror with its wiring.
Now place the tilting mirror, screw it in and connect the cable to the door guide by doing the reverse procedure described above.